問答精選
首頁 / 問答精選
精簡負載點電源供應系統設計的探討
- Q: 贵公司提供的电源设计方案能解决EMI的问题吗?
- A: 开关电源的EMI的问题都是在系统的设计中通过磁珠,RC网络还有layout来解决。国半的simple switcher controller在对外MOSFET的驱动上有在效率和开关速度上有做trade-off的优化。所以使用simple switcher controller对解决EMI有帮。
- Q: 采用这种技术,效率能达到多少,提供的最大工作电流是多少,外围器件多吗,芯片面积如何?
- A: 您问得很好!LM3150的效率一般都会超过90%。最大能提供15A的输出电流。芯片是TSSOP package,面积小,外围件少
- Q: 開關模式電源供應系統,要通過EMI檢驗,有何具體做法和建議。
- A: 很大程度上以来外部原件布局和PCB来减小EMI 建議:減短外部原件距離
- Q: erm模式的是属于pwm还是pfm开关电源?
- A: Basically, ERM is one of PWM, but not pure PWM. The operating frequency is fixed almost on ERM, but transient reponse is better than PWM's.
- Q: 该类开关电源最大可支持的输出电流是多少?
- A: At 12A output, it still have good performance and efficiency. If you need more 12A, the layout and component rating should be care. Normally, single phase operation can offer 25A, if good layout.
- Q: 在pcb设计方面有无特别注意的地方,尤其在EMI方面。
- A: 无特别注意的地方,跟一般電源電路設計一樣,如外部原件布局和PCB来减小EMI
- Q: 請問目前市場上一般來說通常都使用何種方式達到壓降呢?如19V壓降成5V。其轉換效率來說。
- A: 一般使用Buck converter,依據不同輸出電流採非同步整流或同步整流
- Q: 對於講求節能的時代,此電源供應系統的效率可達多少%?
- A: LM3150的效率一般都会高过90%!
- Q: ERM能否用于升压
- A: 目前,国半只有ERM降压的产品。但国半正在设计ERM升压产品!
- Q: Can you talk about capacitor choice on this circuit? Is ESR important?
- A: For ERM, output capacitor ESR is not so important to maintain power system stability, becasue ERM use low side MOSFET Rds_on as signal feedback. If you concern output voltage ripple, small ESR and big capacitance can get good ripple.
- Q: can you provide samples to us?
- A: The sample can be applied thru our web . Or you cantact our distributors to get sample . Distribution information you can find at http://www.national.com/contacts/Continent/0,1594,Asia,00.html
- Q: 開關模式電源供應系統对安装环境有什么要求吗?
- A: Depends on your end application. Switching power has bigger noise than Linear regulator. A good switching power supply has good EMC, and PSRR to maintain good output even in noise environment.
- Q: How do we contact your Office of the Guangdong?Thanks!
- A: 以下是我们深圳办事处的联络方式,您也可以在网上查询到我们各家代理商在贵公司附近的联系方式。 Tel: +86-755-2583-6188 Fax: +86-755-8246-5073 National Semiconductor South China Office (Room 1709 Di Wang Commercial Centre Shun Hing Square 5002 Shennan Road East Shenzhen 518001 , China)
- Q: 请问增加one-shot部分后,操作频率可以固定吗?
- A: 增加One-shot电路后,电源的工作频率在输入电压和负载变化的情况下基本保持不变。然而输出电压的变化还是会引起频率的变动。
- Q: 穩定度怎么保证的?
- A: In general, stability is measured by netwrok analyser. The best case is phase margin over 45 degree.
- Q: 電路板走線有什么特别要求吗?
- A: 沒有特别要求.跟一般開關電源電路設計一樣,如外部原件布局和PCB来减小EMI
- Q: 如果需要较大的输出电容,应该如何选择
- A: 在datasheet中,您可以找到 5.Determin output capacitance这一节。里面有详细的输出电容选择要求。您也可以利用可下载的计算工具帮助选择输出电容。
- Q: 比一般的系统成本控制方面有什么不同吗?
- A: Simple Switcher Controller 的应用优势是设计的简单性,加上由于不再需要环路设计,使电源设计的BOM和设计周期相对于普通PWM控制器都大为缩短。这是在成本控制上能看到的最显著不同。
- Q: 精簡負載點電源供應效率是否可突破到95%以上?
- A: Efficiency depends on Vin and Vout, Iout. It's possible to achive 95%.
- Q: 专家您好,问一个问题:普通DC/DC在输出电流比较小的时候效率往往很低,那么National Semiconductor的新技术是否也有这样的特点吗?
- A: Because there is switching loss on MOSFET on/off at switching power, at light load, the switching loss is dominated. Reduce frequency (skip mode) can improve efficiency. National Semiconductor built-in this feature in many products.
--- 現有 55 個主題,共 3 頁,目前第 1 頁 ---




|